Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Assign Global Hot Spare

Table 1. omconfig Assign Global Hot Spare . The following table describes the syntax and sample syntaxes for the omconfig Assign Global Hot Spare command.

Description

Assigns a physical disk as a global hot spare.

Syntax

omconfig storage pdisk action=assignglobalhotspare controller=id pdisk=< PDISKID> assign=yes , where id is the controller ID. The <PDISKID> variable specifies the physical disk.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example to

Assign physical disk 3 on connector 0 of controller 1 as a global hot spare. On a SAS controller, the physical disk resides in enclosure 2.

Example for SCSI, SATA, and ATA controllers

omconfig storage pdisk action=assignglobalhotspare controller=1 pdisk=0:3 assign=yes

Example for SAS controllers

omconfig storage pdisk action=assignglobalhotspare controller=1 pdisk=0:2:3 assign=yes


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\