Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig autoconfigure RAID0

Table 1. Omconfig autoconfigure RAID-0. The following table describes the process to automatically configures RAID–0 with all disks that are in ready state.

Description

Automatically configures RAID–0 with all disks that are in ready state.

Syntax

omconfig storage controller action=autoconfigureRAID0 controller=id , where id is the controller ID as reported by the omreport storage controller command.

Example to

Automatically configure RAID–0 with other disks.

Example

omconfig storage controller action=autoconfigureRAID0 controller=1


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\