Dell EMC OpenManage Command Line Interface Guide Version 9.1


Omconfig blink virtual disk

Table 1. Omconfig blink virtual disk. The following table describes the syntax and sample syntaxes for the omconfig blink virtual disk command.


Blinks the physical disks included in a virtual disk.


omconfig storage vdisk action=blink controller=id vdisk=id , where id is the controller ID and virtual disk ID as reported by the omreport command.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example to

Blink the physical disks in virtual disk 4 on controller 1.


omconfig storage vdisk action=blink controller=1 vdisk=4

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\