Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig chassis frontpanel or omconfig mainsystem frontpanel

Use the omconfig chassis frontpanel or omconfig mainsystem frontpanel command to:
  • configure the power button and the Nonmasking Interrupt (NMI) button
  • configure the LCD to display:
    • No information
    • Custom information
    • Default system information
    • Service tag, system name
    • Remote access MAC addresses
    • System power
    • Remote access IP address
    • Ambient temperature of the system
    • Remote access IPv4 address
    • Remote access IPv6 address
  • Specify and configure the LCD line number
  • View the encryption state report of the LCD
  • Configure LCD to indicate an active remote session when the Kernel-based Virtual Machine (KVM) is available
  • NOTE: You can configure the Power and NMI buttons only if they are present on the system.

The following table displays the valid parameters for the command:

Table 1. Valid Parameters Of Omconfig Chassis Frontpanel Or Omconfig Mainsystem Frontpanel . This table list the Valid Parameters Of Omconfig Chassis Frontpanel Or Omconfig Mainsystem Frontpanel
name=value pair 1 name=value pair 2 Description
lcdindex=< index> NA Specifies the LCD line number.
config=none | default | custom NA
  • none: Sets the LCD text to none.
  • default: Sets the LCD text to default.
  • custom: Sets the LCD text to custom.
text=< custom text> NA Sets the custom text for LCD when config=custom.
nmibutton=enable | disable NA
  • enable: Enables the NMI button on the system.
  • disable: Disables the NMI button on the system.
powerbutton=enable | disable NA
  • true: Enables the Power button on the system.
  • false: Disables the Power button on the system.
config=sysname NA Sets the name of the system.
config=syspower NA Sets the system power information.
config=servicetag NA Sets the system service tag information.
config=remoteaccessipv4 NA Sets the remote access IPv4 information.
config=remoteaccessipv6 NA Sets the remote access IPv6 information.
config=remoteaccessmac NA Sets the remote access MAC address.
config=ipv4idrac   Sets IPv4 DRAC information.
config=ipv6idrac   Sets IPv6 DRAC information.
config=macidrac NA Sets the DRAC’s MAC address.
config=ambienttemp NA Sets the system temperature in centigrade.
security=modify NA Allows you to modify the LCD text.
security=view NA Provides read-only access to the LCD text.
security=disabled NA Provides limited access to the LCD text.
remoteindication=true NA LCD flashes when the system detects an active remote session.
  • NOTE: The options ipv4idrac, ipv6idrac, and macidrac are deprecated.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\