Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Chassis Leds Or Omconfig Mainsystem Leds

Use the omconfig chassis leds or omconfig mainsystem leds command to specify when to flash a chassis fault LED or chassis identification LED. This command also allows you to clear the LED of the system hard drive. The following table displays the valid parameters for the command.

Table 1. Valid Parameters Of Omconfig Chassis Leds Or Omconfig Mainsystem Leds . This table lists the Valid Parameters Of Omconfig Chassis Leds Or Omconfig Mainsystem Leds
name=value pair 1 name=value pair 2 Description
index=< n> NA Number of the chassis where the LED resides (defaults to chassis 0, main system chassis).
led=fault severity=warning | critical Select to flash the LED either when a warning event occurs or when a critical event occurs.
led=hdfault action=clear Sets the number of faults for the hard drive back to zero (0).
led=identify flash=off | on time-out=< n> Sets the chassis identification LED to off or on. Set the time-out value for the LED to flash to a number of seconds.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\