Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Chassis Pwrmonitoring Or Omconfig Mainsystem Pwrmonitoring

Use the omconfig chassis pwrmonitoring or omconfig mainsystem pwrmonitoring command to configure power consumption information.

The following table displays the valid parameters for the command:

Table 1. Valid Parameters Of Omconfig Chassis Pwrmonitoring Or Omconfig Mainsystem Pwrmonitoring . This table lists the Valid Parameters Of Omconfig Chassis Pwrmonitoring Or Omconfig Mainsystem Pwrmonitoring
name=value pair 1 name=value pair 2 Description
index=< n> NA Number of the probe or probe index (must specify).
config=probe warnthresh=settodefault Sets the minimum and maximum warning thresholds values to default.
  warnthresh=< n > Sets a value for the warning threshold.
  unit=watt | btuphr

watt: Displays the unit in Watts.

btuphr: Displays the unit in BTU/hr.

config=resetreading type=energy | peakpower

energy: Resets the system energy reading.

peakpower: Resets the system peak power.

  • NOTE: This command is applicable only on selected Dell 10G systems that support PMBus.
  • NOTE: Power monitoring requires license to configure the power budget information. If the appropriate license is not installed or has expired, the system displays an error message. For more information, see Dell License Manager at dell.com/openmanagemanuals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\