Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Check Consistency

Table 1. omconfig Check Consistency . The following table describes the syntax and sample syntaxes for the o mconfig Check Consistency command.

Description

Initiates a check consistency on a virtual disk. The check consistency task verifies the virtual disk’s redundant data.

Syntax

omconfig storage vdisk action=checkconsistency controller=id vdisk=id , where id is the controller ID and virtual disk ID as reported by the omreport command.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example to

Run a check consistency on virtual disk 4 on controller 1.

Example

omconfig storage vdisk action=checkconsistency controller=1 vdisk=4


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\