Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Convert Multiple Non-RAID To RAID

Table 1. Omconfig Convert Multiple Non-RAID To RAID. The following table describes the process to convert multiple non-RAID to RAID on the given controller.

Description

Converts multiple non-RAID to RAID on the given controller.

Syntax

omconfig storage controller action=convertnonraidtoraid controller=id pdisk=< PDISKID> , where id is the controller ID as reported by the omreport storage controller command and PDISKID is specified as pdisk=connector:enclosureID:targetID | connector:targetID.

Example to

Convert multiple non-RAID to RAID on controller 0,

Example

omconfig storage controller action=convertnonraidtoraid controller=0 pdisk=0:2:3


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\