Dell EMC OpenManage Command Line Interface Guide Version 9.1


Omconfig Convert RAID To Non-RAID

Table 1. Omconfig Convert RAID To Non-RAID . The following table describes the syntax and sample syntaxes for the omconfig Convert RAID To Non-RAID command.


Converts RAID to non-RAID on a physical disk.


omconfig storage pdisk action=convertraidtononraid controller=id pdisk=< PDISKID> , where id is the controller ID. The <PDISKID> variable specifies the physical disk.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example to

Convert RAID to non-RAID on physical disk 3 on connector 0 of controller 1. On a SAS controller, the physical disk resides in enclosure 2.

Example for SAS controllers

omconfig storage pdisk action=raidtononraid controller=1 pdisk=0:2:3

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\