Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Disable Enclosure Alarm

Table 1. Omconfig Disable Enclosure Alarm . The following table describes the process to disable the enclosure alarm.

Description

Disables the enclosure alarm.

Syntax

omconfig storage enclosure action=disablealarm controller=id enclosure=< ENCLOSUREID> , where idis the controller ID. The < ENCLOSUREID> variable specifies the enclosure.

Example to

Disables the alarm on enclosure 2 attached to connector 1 on controller 1.

Example for SCSI, SATA, and ATA controllers

omconfig storage enclosure action=disablealarm controller=1 enclosure=2

Example for SAS controllers

omconfig storage enclosure action=disablealarm controller=1 enclosure=1:2


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\