Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Fast Initialize Virtual Disk

Table 1. omconfig Fast Initialize Virtual Disk . The following table describes the syntax and sample syntaxes for the omconfig Fast Initialize Virtual Disk command.

Description

Fast initializes a virtual disk.

  • CAUTION: You may receive a warning message if you attempt to delete the system or boot partition. However, this warning message is not generated always. Ensure that you do not delete the system or boot partition or other vital data when using this command.

Syntax

omconfig storage vdisk action=fastinit controller=id vdisk=id , where id is the controller ID and virtual disk ID as reported by the omreport command.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
  • NOTE: In some circumstances, you may receive a warning message if this command deletes the system or boot partition. You can override this warning by using the force=yes parameter. In this case, the syntax is as follows:
    omconfig storage vdisk action=fastinit controller=id vdisk=id force=yes

Example to

Fast initialize virtual disk 4 on controller 1.

Example

omconfig storage vdisk action=fastinit controller=1 vdisk=4


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\