Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Initialize Physical Disk

Table 1. omconfig Initialize Physical Disk . The following table describes the syntax and sample syntaxes for the omconfig Initialize Physical Disk command.

Description

Initializes a physical disk.

Syntax

omconfig storage pdisk action=initialize controller=id pdisk=id , where id is the controller ID and physical disk ID as reported by the omreport command.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example to

Initialize physical disk 4 on controller 1

Example

omconfig storage pdisk action=initialize controller=1 pdisk=1:0:4


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\