Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Physical Disk Commands

The following sections provide the omconfig command syntax required to run physical disk tasks:

Table 1. omconfig Physical Disk Commands . The following table describes the omconfig command syntax required to run related physical disk tasks.
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage pdisk action=blink controller=id pdisk=<PDISKID>
  action=unblink controller=id pdisk=<PDISKID>
  action=remove controller=id pdisk=<PDISKID>
  action=instantsecureerase controller=id pdisk=<PDISKID>
  action=cryptographicerase controller=id pdisk=<PDISKID>
  action=initialize controller=id pdisk=<PDISKID>
  action=offline controller=id pdisk=<PDISKID>
  action=online controller=id pdisk=<PDISKID>
  action=assignglobalhotspare controller=id pdisk=<PDISKID> assign=<yes | no>
  action=rebuild controller=id pdisk=<PDISKID>
  action=cancelrebuild controller=id pdisk=<PDISKID>
  action=cancelreplacemember controller=id pdisk=<PDISKID>
  action=clear controller=id pdisk=<PDISKID>
  action=cancelclear controller=id pdisk=<PDISKID>
  action=enabledevicewritecache controller=id pdisk=<PDISKID>
  action=disabledevicewritecache controller=id pdisk=<PDISKID>
  action=exportlog controller=id pdisk=<PDISKID> [filename=<filename>], the filename mentioned here is optional.
  action=convertraidtononraid controller=id pdisk=<PDISKID>
  action=convertnonraidtoraid controller=id pdisk=<PDISKID>
  action=setarraydiskcache controller=id pdisk=<PDISKID>

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\