Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Prepare To Remove Physical Disk

Table 1. omconfig Prepare To Remove Physical Disk . The following table describes the syntax and sample syntaxes for the omconfig Prepare To Remove Physical Disk command.

Description

Prepares a physical disk for removal.

Syntax

omconfig storage pdisk action=remove controller=id pdisk=< PDISKID> , where id is the controller ID. The <PDISKID> variable specifies the physical disk.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example to

Prepares physical disk 3 on connector 0 of controller 1 for removal. On a SAS controller, the physical disk resides in enclosure 2.

Example for SCSI, SATA, and ATA controllers

omconfig storage pdisk action=remove controller=1 pdisk=0:3

Example for SAS controllers

omconfig storage pdisk action=remove controller=1 pdisk=0:2:3


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\