Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Rebuild Physical Disk

Table 1. omconfig Rebuild Physical Disk . The following table describes the syntax and sample syntaxes for the omconfig Rebuild Physical Disk command.

Description

Rebuilds a failed physical disk. Rebuilding a disk may take several hours. If you need to cancel the rebuild, use the Cancel Rebuild task. For more information about Rebuild Physical Disk, see the Dell EMC OpenManage Online Help.

Syntax

omconfig storage pdisk action=rebuild controller=id pdisk=< PDISKID> , where id is the controller ID. The <PDISKID> variable specifies the physical disk.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example to

Rebuild physical disk 3 on connector 0 of controller 1. On a SAS controller, the physical disk resides in enclosure 2.

Example for SCSI, SATA, and ATA controllers

omconfig storage pdisk action=rebuild controller=1 pdisk=0:3

Example for SAS controllers

omconfig storage pdisk action=rebuild controller=1 pdisk=0:2:3


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\