Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Rescan Connector

Table 1. Omconfig Rescan Connector. Rescans a controller connector. This command rescans all connectors on the controller and is therefore similar to performing a controller rescan.

Description

Rescans a controller connector. This command rescans all connectors on the controller and is therefore similar to performing a controller rescan.

  • NOTE: This command is not supported on SAS controllers.

Syntax

omconfig storage connector action=rescan controller=id connector=id , where id is the controller ID and the connector ID as reported by the omreport command. To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage connector controller=ID to display the IDs for the connectors attached to the controller.

Example to

Rescan connector 2 on controller 1.

Example

omconfig storage connector action=rescan controller=1 connector=2


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\