Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Reset All Temperature Probe Thresholds

Table 1. Omconfig Reset All Temperature Probe Thresholds . The following table describes the process to reset the minimum and maximum warning temperature thresholds back to their default value for all temperature probes in the enclosure.

Description

Resets the minimum and maximum warning temperature thresholds back to their default value for all temperature probes in the enclosure.

  • NOTE: This command is not supported on SCSI RAID controllers.

Syntax

omconfig storage enclosure action=resetalltempprobes controller=id enclosure=< ENCLOSUREID> , where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.

In this syntax, n is a user-specified alphanumeric string.

Example to

Reset the thresholds for all temperature probes in enclosure 3 attached to connector 2 on controller 1.

Example for SAS controllers

omconfig storage enclosure action= resetalltempprobes controller=1 enclosure=2:3


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\