Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Reset Temperature Probe Thresholds

Table 1. omconfig Reset Temperature Probe Thresholds . The following table describes the omconfig Reset Temperature Probe Thresholds command.

Description

Resets the minimum and maximum warning temperature thresholds back to their default values.

  • NOTE: This command is not supported on SAS controllers.

Syntax

omconfig storage enclosure action=resettempprobes controller=id enclosure=< ENCLOSUREID> index=id , where id is the controller ID and the temperature probe ID. The <ENCLOSUREID> variable specifies the enclosure.

In this syntax, n is a user-specified alphanumeric string.

Example to

Reset the thresholds for temperature probe 3, residing in the enclosure attached to connector 2 on controller 1, to the default values.

Example for SCSI, SATA, and ATA controllers

omconfig storage enclosure action=resettempprobes controller=1 enclosure=2 index=3

  • NOTE: Here, temperature probe 3 resides in the enclosure attached to connector 2 on controller 1.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\