Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig set controller mode

Table 1. Omconfig set controller mode. The following table describes the process to set the mode of the controller to RAID or HBA.

Description

Sets the mode of the controller to RAID or HBA.

Syntax

omconfig storage controller action=setcontrollermode controller=id mode=raid|hba , where id is the controller ID as reported by the omreport storage controller command.

  • NOTE: If a virtual disk, hotspare, or encryption key is enabled on the controller, the controller mode cannot be changed to HBA. Reboot the system for the change to take effect.

Example to

Set the controller mode to HBA.

Example

omconfig storage controller action=setcontrollermode controller=1 mode=hba


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\