Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Set Controller Rebuild Rate

Table 1. Omconfig Set Controller Rebuild Rate. The following table describes the process to set the controller rebuild rate.

Description

Sets the controller rebuild rate.

Syntax

omconfig storage controller action=setrebuildrate controller=id rate=<0 to 100> , where id is the controller ID as reported by the omreport storage controller command.

Example to

Set the rebuild rate to 50 on controller 1.

Example

omconfig storage controller action=setrebuildrate controller=1 rate=50


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\