Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Set Patrol Read Mode

Table 1. Omconfig Set Patrol Read Mode. The following table describes the process to set the patrol read mode for the controller.

Description

Sets the patrol read mode for the controller.

Syntax

omconfig storage controller action= setpatrolreadmode controller=id mode= manual|auto|disable , where id is the controller ID as reported by the omreport storage controller command.

Example to

Sets the patrol read on controller 1 to manual mode

Example

omconfig storage controller action= setpatrolreadmode controller=1 mode=manual


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\