Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Set Temperature Probe Thresholds

Table 1. Omconfig Set Temperature Probe Thresholds . The following table describes the process to set the minimum and maximum warning temperature thresholds for a specified temperature probe.

Description

Sets the minimum and maximum warning temperature thresholds for a specified temperature probe.

  • NOTE: This command is not supported on SAS controllers.

Syntax

omconfig storage enclosure action=settempprobes controller=id enclosure=< ENCLOSUREID> index=id minwarn=n maxwarn=n , where id is the controller ID and the temperature probe ID. The <ENCLOSUREID> variable specifies the enclosure.

In this syntax, n is a user-specified alphanumeric string.

Example to

Set the temperature probe thresholds to 10 and 40 degree Celsius.

Example for SCSI, SATA, and ATA controllers

omconfig storage enclosure action=settempprobes controller=1 enclosure=2 index=3 minwarn=10 maxwarn=40

  • NOTE: Here, temperature probe 3 resides in the enclosure attached to connector 2 on controller 1.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\