Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Stop Patrol Read

Table 1. Omconfig Stop Patrol Read. The following table describes the process to stop the patrol read task on the controller.

Description

Stops the patrol read task on the controller.

Syntax

omconfig storage controller action=stoppatrolread controller=id , where id is the controller ID as reported by the omreport storage controller command.

Example to

Stop the patrol read task on controller 1.

Example

omconfig storage controller action=stoppatrolread controller=1

  • NOTE: To stop patrol read, the current patrol read mode is set to Manual.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\