Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig System Recovery Or Omconfig Servermodule Recovery

Use the omconfig system recovery or omconfig servermodule recovery command to set the action when the operating system hangs or crashes. You can also set the number of seconds that must pass before the system is considered to have a hung operating system. The following table lists the valid parameters for the command

  • NOTE: The upper and lower limits for the timer depend on the system model and configuration.
Table 1. Valid Parameters Of Omconfig System Recovery Or Omconfig Servermodule Recovery . The following table describes the command and its result.
name=value pair Description
action=none Takes no action when the operating system is hung or has crashed.
action=reboot Shuts down the operating system and initiates system startup, performing BIOS checks, and reloading the operating system.
action=poweroff Turns off electrical power to the system.
action=powercycle Turns off electrical power to the system, pauses, turns on the power, and reboots the system. Power cycling is useful when you want to reinitialize system components such as hard drives.
timer=< n> Number of seconds that must pass before the system is considered to have a hung operating system (from 20 seconds to 480 seconds).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\