Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig system snmptraptest or omconfig servermodule snmptraptest

Use the omconfig system snmptraptest or omconfig servermodule snmptraptest command to send the snmp test trap to the destination address if Server Administrator SNMP component is configured in the configuration file.

The following table displays the valid parameters for the command:

Table 1. Parameters For Alert Action Command . The following table describes the action and the related description of the action.
Action Description

dest=< ipv4 address | ipv6 address | fqdn>

Send the test trap to the destination IP address.

  • NOTE: This feature is not supported on VMware ESXi.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\