Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig Unblink Physical Disk

Table 1. omconfig Unblink Physical Disk . The following table describes the syntax and sample syntaxes for the omconfig Unblink Physical Disk command.

Description

Unblinks the light (light emitting diode or LED display) on one or more physical disks attached to a controller.

Syntax

omconfig storage pdisk action=unblink controller=id pdisk=< PDISKID> , where id is the controller ID. The <PDISKID> variable specifies the physical disk.

  • NOTE: To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example to

Unblink physical disk 0 on connector 0 of controller 1. On a SAS controller, the physical disk resides in enclosure 2.

Example for SCSI, SATA, and ATA controllers

omconfig storage pdisk action=unblink controller=1 pdisk=0:0

Example for SAS controllers

omconfig storage pdisk action=unblink controller=1 pdisk=0:2:0


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\