Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omconfig virtual disk commands

The following table provides the omconfig command syntax required to run virtual disk tasks.

  • CAUTION: The omconfig storage vdisk action=deletevdisk controller=id vdisk=id command deletes a virtual disk. Deleting a virtual disk destroys all information including file systems and volumes residing on the virtual disk.
Table 1. Omconfig Manage Virtual Disk Commands . The following table describes the omconfig command syntax required to run virtual disk tasks.
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage vdisk action=checkconsistency controller=id vdisk=id
  action=cancelcheckconsistency controller=id vdisk=id
  action=pausecheckconsistency controller=id vdisk=id
  action=resumecheckconsistency controller=id vdisk=id
  action=checkconsistency controller=id vdisk=id
  action=blink controller=id vdisk=id
  action=unblink controller=id vdisk=id
  action=initialize controller=id vdisk=id
  action=fastinit controller=id vdisk=id [force=yes]
  action=slowinit controller=id vdisk=id [force=yes]
  action=cancelinitialize controller=id vdisk=id
  action=cancelbginitialize controller=id vdisk=id
  action=assigndedicatedhotspare controller=id vdisk=id pdisk=<PDISKID> assign=<yes | no>
  action=deletevdisk controller=id vdisk=id [force=yes]
  action=reconfigure controller=id vdisk=id raid=<c | r0 | r1 | r1c | r5 | r10> pdisk=<PDISKID> [size=<size> vdcapacityexpansion=yes sizeinpercent=<1 to 100>]
  action=securevd controller=id vdisk=id
  action=clearvdbadblocks controller=id vdisk=id
  ction=changepolicy controller=id vdisk=id [readpolicy=<ra | nra | ara | rc | nrc> | writepolicy=<wb | wt | wc | nwc | fwb> | cachepolicy=<d | c> diskcachepolicy=<enabled | disabled>]
  action=replacememberdisk controller=id vdisk=id source=<PDISKID> destination=<PDISKID>
  action=rename controller=id vdisk=id
  action=enablefluidcache controller=id vdisk=id devicename=<string> cachepolicy=<wb | wt>
  action=disablefluidcache controller=id vdisk=id devicename=<string>
  action=reactivate controller=id vdisk=id devicename=<string>

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\