Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omreport Connector Status

The following table describes the syntax for the omreport Connector commands:

Table 1. omreport Connector Commands . The following table describes the syntax for the omreport Connector command and its usage.
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage connector  

Displays all connectors present on all controllers on the system.

  • NOTE: This command works only when the controller ID is specified.
  controller=id, where id is the controller number. For example: controller=0 Displays the connectors on the specified controller.
  controller=id connector=id, where id is the connector number. For example, connector=0

Displays the specified connector.

  • NOTE: When the connectors are connected to the enclosure in redundant path mode, the Name of the connector is displayed as Logical Connector.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\