Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omreport EMM Status

The following table describes the syntax for the omreport EMM commands:

  • NOTE: The status of the EMMs is displayed as degraded if there is a mismatch between the EMM firmware.
Table 1. Omreport EMM Commands . The following table describes the syntax for the omreport EMM command and its usage.
Required Command Levels (1, 2, 3) and name=value pair Optional name=value pairs Use
omreport storage enclosure   Displays property information for all enclosures attached to the system.
  controller=id enclosure=<ENCLOSUREID> info=emms where id is the controller number and ENCLOSUREID is the enclosure number. For example: controller=0 enclosure=2 Displays the enclosure management modules (EMMs) for the specified enclosure.
  controller=id enclosure=<ENCLOSUREID> info=emms index=n where id is the controller number and ENCLOSUREID is the enclosure number and n is the number of an EMM. For example: controller=0 enclosure=2 info=emms index=1 Displays the specified EMMs.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\