Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omreport Enclosure Status

The following sections provide the omreport storage enclosure command syntax required to execute the enclosure commands. The following table describes the syntax for the omreport Enclosure commands.

Table 1. omreport Enclosure Commands . The following table describes the syntax for the omreport Enclosure commands and its usage.
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage enclosure   Displays property information for all enclosures attached to the system.
  controller=id, where id is the controller number Displays all enclosures connected to the controller.
  controller=id enclosure=<ENCLOSUREID>, where id is the controller number and <ENCLOSUREID>is the enclosure ID. Example for SCSI controllers: controller=0 enclosure=2. Example for SAS controllers: controller=0 enclosure=1:2. Displays the specified enclosure and its components.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\