Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omreport Physical Disk Status

The following table describes the syntax for the omreport Physical Disk commands.

Table 1. Omreport Physical Disk Commands . The following table describes the syntax for the omreport Physical Disk commands.
Required Command Levels (1, 2, 3) And name=value pair Optional name=value pairs Use
omreport storage pdisk controller=id, where id is the controller number. For example, controller=0

Displays all physical disks attached to the specified controller.

  • NOTE: If a physical disk was replaced by another disk as part of the replace member operation, the state of the physical disk is displayed as Replacing.
  vdisk=id, where id is the virtual disk number. For example, vdisk=1 Displays all physical disks included in the specified virtual disk on the controller.
  cachecade=id where id is the cachecade number. For example, cachecade=1 Displays all physical disks included in the specified cachecade on the controller.
  connector=id where id is the connector number. For example, connector=1 Displays all physical disks attached to the specified connector on the controller.
  pdisk=connectorID: targetID | connectorID: enclosureID: slotID, where connectorID: targetID is the connector number and the physical disk number and connectorID:enclosureID: slotID is the connector number, enclosure number, and slot number. For example, pdisk=0:2 or pdisk=0:1:2 Displays the specified physical disk on the specified connector on the controller.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\