Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omreport Storage Tape

The following table describes the syntax for the omreport storage tape command.

Table 1. Omreport Storage Tape Commands . The following table describes the syntax for the omreport storage tape command and its usage.
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage tape   Display tape drive properties.
  controller=id, where id is the controller number. For example: controller=0. Displays all tape drives.
  connector=id Displays all the tape drives on the specified connector.
  tape=<tape id>, where tapeid=id=<connector:targetID> Displays the specified tape drive.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\