Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Omreport Temperature Probe Status

The following table describes the syntax for the omreport Probe commands:

Table 1. omreport Temperature Probe Commands . The following table describes the syntax for the omreport Probe command and its usage.
Required Command Levels (1, 2, 3) and name=value pair Optional name=value pairs Use
omreport storage enclosure   Displays property information for all enclosures attached to the system.
  controller=id enclosure=<ENCLOSUREID> info=temps where id is the controller number and <ENCLOSUREID> is the enclosure ID. Example for SCSI controllers: controller=0 enclosure=2 info=temps. Example for SAS controllers: controller=0 enclosure=1:2 info=temps Displays the temperature probes for the specified enclosure.
  controller=id enclosure=<ENCLOSUREID> info=temps index=n where id is the controller number and <ENCLOSUREID> is the enclosure number and n is the number of a temperature probe. For example: controller=0 enclosure=2 info=temps index=1 Displays the temperature probes for the specified enclosure.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\