Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Syntax Of Command Elements

The omreport and omconfig commands have multiple name=value pairs. These name=value pairs may include required, optional, and variable parameters. The following table describes the syntax used to indicate these parameters.

Table 1. Syntax For Name=Value Pairs . The following table describes the syntax of the command and the corresponding result.
Syntax Description
controller=id

Indicates the controller ID as reported by the omreport storage controller command. To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=id to display the IDs for the physical disks attached to the controller.

For example, the controller=id parameter is specified as controller=1.

connector=id

Indicates the connector ID as reported by the omreport command. To obtain this value, type omreport storage controller to display the controller IDs and then type omreport storage connector controller=id to display the IDs for the connectors attached to the controller.

For example, the connector=id parameter is specified as connector=2.

vdisk=id

Indicates the virtual disk ID as reported by the omreport command. To obtain this value, type omreport storage controller to display the controller IDs and then type omreport storage vdisk controller=id to display the IDs for the virtual disks on the controller.

For example, the vdisk=id parameter is specified as vdisk=3.

enclosure=<ENCLOSUREID>

Indicates a particular enclosure by specifying either enclosure=connector or enclosure=connector:enclosureID.

To obtain these values, type omreport storage controller to display the controller IDs and then type omreport storage enclosure controller=id to display the IDs for the enclosures attached to the controller.

pdisk=<PDISKID>

Indicates a particular physical disk by specifying either connector:targetID or connector:enclosureID:targetID.

To obtain the values for the connector, enclosure, and physical disk (targetID), type omreport storage controller to display the controller IDs and then type omreport storage pdisk controller=id to display the IDs for the physical disks attached to the controller.

battery=id

Indicates the battery ID as reported by the omreport command. To obtain this value, type omreport storage controller to display the controller IDs and then type omreport storage battery controller=id to display the ID for the controller battery.

< >

The caret symbols (< >) enclose variable elements that you must specify.

For example, the name=<string>parameter is specified as name=VirtualDisk1.

[ ]

The bracket symbols ([ ]) indicate optional elements that you can choose whether or not to specify.

For example, when creating a virtual disk, the [name=<string>] parameter indicates that you have the option of specifying the virtual disk name. If you omit this parameter from the syntax, then a default name for the virtual disk is chosen for you.

|

The pipe symbol (|) separates two or more options from which only one is selected.

For example, when creating a virtual disk, the cachepolicy=d | c indicates that the cache policy is specified as either cachepolicy=d or cachepolicy=c.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\