Dell OpenManage SNMP Reference Guide for iDRAC and Chassis Management Controller
Server Administrator Remote Access MIB
- NOTE: This section contains information that is applicable only if the Server Administrator is installed in the system.
The Server Administrator Remote Access MIB ( filename dcs3rmt.mib ) provides in-band information about remote access hardware that may be present in your system.
The Server Administrator Remote Access MIB structures its MIB objects into groups of scalar objects or MIB tables that provide related information. Table below describes each Server Administrator Remote Access MIB group and lists the MIB group number assigned to the MIB group. The Server Administrator Remote Access MIB groups are identified by the SNMP OID 1.3.6.1.4.1.674.10892.1.< MIB group number> where < MIB group number> is the MIB group number assigned to the MIB group. See the relevant section for more information about the MIB objects defined in a MIB group.
| Topic | MIB Group Numbers |
|---|---|
| Remote Access Group — provides information about remote access hardware that may be present in your system and defines variables for administrative users, SNMP trap destinations, modem configuration for dial-up networking, dial-in configuration, and dial-out destinations | 1700 |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\