Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Installing the display back-cover and antenna assembly

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The image below shows the display back-cover and antenna assembly.

Figure 1. Display back-cover and antenna assembly
Removing display assembly back cover

Steps

Place the display back-cover and antenna assembly on a flat surface and perform the Next steps to install the display back-cover and antenna assembly.

Next steps

  1. Install the display cable for RGB/IR camera or the display cable for MIPI camera, as applicable.
  2. Install the RGB/IR camera or the MIPI camera, as applicable.
  3. Install the display hinge cap.
  4. Install the display panel.
  5. Install the display bezel.
  6. Install the display assembly.
  7. Install the WWAN card, if applicable.
  8. Install the base cover.
  9. Install the SIM-card tray, if applicable.
  10. Follow the procedure in After working inside your computer .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\