Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

Installing the display cable for RGB/IR camera

CAUTION:The information in this installation section is intended for authorized service technicians only.

NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE: This procedure applies only to models that are shipped with RGB or IR camera.

The following images indicate the location of the display cable and provide a visual representation of the installation procedure.

Adhere the display cable to the display back-cover and antenna assembly.
Connect the display cable to the connector on the camera module.
Carefully route the display cable through the display-hinge cap.
Align and place the left-hinge cap on the display back cover.
Gently press the left-hinge cap to secure it to the display back cover.
Replace the screw (M2x3) and the two screws (M2.5x3.5) to secure the left-display hinge cap to the display back cover.
Align and insert the hinge rubber into the left hinge cap to secure the display cable.