Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Installing the display hinge caps

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE:The display hinges are a part of the display hinge caps.
The following images indicate the location of the display hinge caps and provide a visual representation of the installation procedure.
Figure 1. Installing the display hinge caps
Image: Installing the display hinge cap

Steps

  1. Route the display/camera cable and WWAN antenna/Darwin cable through the respective hinge caps.
  2. Align and place the display hinge caps on the display back cover.
  3. Replace the two screws (M2x3) and four screws (M2.5x3.5) that secure the display hinge caps to the display back cover.
  4. Replace the hinge rubber stopper into the left and right hinge caps.

Next steps

  1. Install the display panel.
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the WWAN card, if applicable.
  5. Install the base cover.
  6. Install the SIM-card tray, if applicable.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\