Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Installing the display panel

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

About this task

The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
Figure 1. Installing the display panel
Image: Installing the display panel
Figure 2. Installing the display panel
Image: Installing the display panel

Steps

  1. Place the display panel and display assembly on a clean and flat surface.
  2. Connect the display cable to the connector on the display panel.
  3. Adhere the tape to secure the display cable to the connector on the display panel.
  4. Gently turn the display panel over and place the display panel in the slot on the display back cover.
  5. Replace the four screws (M1.6x1.4) to secure the display-panel brackets to the display back-cover and antenna assembly.

Next steps

  1. Install the display bezel.
  2. Install the display assembly.
  3. Install the WWAN card, if applicable.
  4. Install the base cover.
  5. Install the SIM-card tray, if applicable.
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\