Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Installing the memory module

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the memory module and provide a visual representation of the installation procedure.
Figure 1. Installing the memory module
Installing the memory modules

Steps

  1. Align the notch on the memory module with the tab on the memory-module slot.
  2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
    CAUTION:To prevent damage to the memory module, hold the memory module by the edges. Do not touch the components or metallic contacts on the memory module as electrostatic discharge (ESD) can inflict severe damage on the components. To read more about ESD protection, see ESD protection.
    NOTE:If you do not hear the click, remove the memory module and reinstall it.
    NOTE:Repeat step 1 and step 2 if there is more than one memory module to be installed on your computer.

Next steps

  1. Install the base cover.
  2. Install the SIM-card tray, if applicable.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\