Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Installing the middle-board cable

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE: This procedure applies only to models shipped with MIPI camera.

The following image indicates the location of the middle-board cable and provides a visual representation of the installation procedure.

Figure 1. Installing the middle-board cable
Image: Installing the middle-board cable

Steps

  1. Place the MIPI camera module on a clean, flat surface.
  2. Turn the middle board over.
  3. Connect the middle-board cable to the connector on the middle board.
  4. Replace the two screws (M1.6x1.4) to secure the middle-board cable to the middle board.

Next steps

  1. Install the MIPI camera.
  2. Install the display hinge caps.
  3. Install the display panel.
  4. Install the display bezel.
  5. Install the display assembly.
  6. Install the WWAN card, if applicable.
  7. Install the base cover.
  8. Install the SIM-card tray, if applicable.
  9. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\