Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Installing the RGB/IR camera

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

About this task

NOTE: This procedure applies only to models that are shipped with RGB or IR camera.
The following images indicate the location of the RGB/IR camera and provide a visual representation of the installation procedure.
Figure 1. Installing the RGB/IR camera
Image: Installing the RGB/IR camera

Steps

  1. Align and place the camera module in the alignment post on the display back-cover and antenna assembly.
  2. Connect the display cable to the connector on the camera module.

Next steps

  1. Install the display panel .
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the WWAN card, if applicable.
  5. Install the base cover.
  6. Install the SIM-card tray, if applicable.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\