Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Removing the display cable for MIPI camera

CAUTION:The information in this removal section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the WWAN card, if applicable.
  5. Remove the display assembly.
  6. Remove the display bezel.
  7. Remove the display panel.
  8. Remove the display hinge caps.
  9. Remove the MIPI camera.

About this task

NOTE: This procedure applies only to models shipped with MIPI camera.

The following image indicates the location of the display cable for MIPI camera and provides a visual representation of the removal procedure.

Figure 1. Removing the display cable for MIPI camera
Image: Removing the display cable for MIPI camera

Steps

  1. Place the MIPI camera module on a clean, flat surface.
  2. Turn the middle board over.
  3. Remove the two screws (M1.6x1.4) that secure the display cable to the middle board.
  4. Disconnect and remove the display cable from the connector on the middle board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\