Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Removing the power button with optional fingerprint reader

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the battery.
  5. Remove the memory module.
  6. Remove the WWAN card, if applicable.
  7. Remove the M.2 2230 solid state drive or the M.2 2280 solid state drive, as applicable.
  8. Remove the system board.
    NOTE:The system board can be removed and installed with the fan and heat-sink assembly attached in order to simplify the procedure and preserve the thermal bond between the system board and fan and heat-sink assembly.
  9. Remove the I/O board.

About this task

The following image indicates the location of the power button with optional fingerprint reader and provides a visual representation of the removal procedure.
Figure 1. Removing the power button with optional fingerprint reader
Image: Removing the power button with optional fingerprint reader

Steps

  1. Remove the two screws (M1.6x1.7) that secure the power button to the palm-rest assembly.
  2. Lift the power button off the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\