Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Removing the smart card reader

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the battery.

About this task

NOTE:This procedure applies only to computers shipped with a smart card reader installed.
The following images indicate the location of the smart card reader and provide a visual representation of the removal procedure.
Figure 1. Removing the smart card reader
Image: Removing the smart card readerImage: Removing the smart card reader

Steps

  1. Remove the three screws (M1.6x1.5) that secure the speaker to the palm-rest assembly.
  2. Release the speaker from the rubber grommets. Carefully remove the speaker and place it away from the palm-rest assembly.
  3. Open the latch and disconnect the smart card reader cable from the USH board.
  4. Peel the smart card reader cable from the palm-rest assembly.
  5. Remove the four screws (M2x2) that secure the smart card reader to the palm-rest assembly.
  6. Lift the smart card reader, along with its cable, off the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\