Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200U Series/Intel Core 100U and 200U Series) Owner's Manual

PDF

Running the SupportAssist Pre-Boot System Performance Check

Steps

  1. Turn on your computer.
  2. As the computer boots, press the F12 key.
  3. On the boot menu screen, select Diagnostics.
    The diagnostic quick test begins.
    NOTE:For more information about running the SupportAssist Pre-Boot System Performance Check on a specific device, see Dell Support Site.
  4. If there are any issues, error codes are displayed.
    Note the error code and validation number and contact Dell.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\