PowerProtect Data Manager 19.10 Cyber Recovery User Guide
Configuring a daily activity report
As the Security Officer (crso), set up a daily Cyber Recovery activity report.
Prerequisites
- You have a valid email address.
- The mail server is enabled. For more information, see Setting up an email server.
NOTE The
Cyber Recovery software can generate and send an activity report without user authentication settings for an external mail server. However, we recommend that you include authentication settings for an external mail server.
About this task
The activity report provides information for all Cyber Recovery jobs for the duration of the configured frequency. Only the Security Officer (crso) receives the report.
NOTE There is no need to configure the Security Officer (crso) to receive alerts.
Steps
- From the Masthead Navigation in the Cyber Recovery UI, click the gear icon to access the System Settings list.
- Click System Reports
- In the System Reports dialog box, click the Activity Report tab and swipe right on the slider to enable the option.
-
Complete the
Frequency and
Next Run fields, and then click
Save.
NOTE The Cyber Recovery UI uses the same time zone as the Cyber Recovery management host for the scheduled time.The maximum number of days is 30 and the minimum number of hours is 1.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\