PowerProtect Data Manager 19.10 Cyber Recovery User Guide

Logging in to the Cyber Recovery UI

Cyber Recovery users can log in to the Cyber Recovery UI.

About this task

Users that are assigned the Security Officer (crso) or Admin roles can perform tasks in Cyber Recovery. A dashboard user can only view the dashboard but cannot perform any tasks.

Steps

Open a supported browser and go to https://<host>:14777, where <host> is the hostname of the management host where the Cyber Recovery software is installed.
The Cyber Recovery software supports the Chrome and Firefox browsers. For the most current information, see the PowerProtect Cyber Recovery Simple Support Matrix.
Enter your username and password.
Click Log In.
If you enabled multifactor authentication, enter the security code in the Security Code field and click Log In.

NOTE Multifactor authentication is a time-based security mechanism. The Cyber Recovery host time cannot differ from the authenticator time by more than one minute (plus or minus). If the time differs by more than +60 seconds or -60 seconds, multifactor authentication is not enabled. For more information, see Enabling multifactor authentication.

Results

The Cyber Recovery dashboard is displayed.

Next steps

For enhanced security, log out of the Cyber Recovery UI when you have completed your Cyber Recovery session.