PowerProtect Data Manager 19.10 Cyber Recovery User Guide

PDF

Resetting the host fingerprint

If you change the hostname (that is, the FQDN or IP address) of either an application or a DD system in the Cyber Recovery vault you must reset the host fingerprint.

Prerequisites

Only the Security Officer role can carry out this task.

About this task

You must reset the host fingerprint in the following cases:
  • If you change from one FQDN to a different FQDN.
  • If you change from an FQDN to an IP address.
  • If you change from an IP address to an FQDN.

In this case, you do not need to reset the host fingerprint:

  • If you change from one IP address to a different IP address.

Steps

  1. To reset the host fingerprint when changing an FQDN or IP address, do one of the following:
    • Select Assets from the Main Menu, and click Applications at the top of the Assets content pane.
    • Select Assets from the Main Menu, and click Vault Storage at the top of the Assets content pane.
  2. Select an existing application or storage asset, and click Edit.
  3. In the dialog box, change the address in the FQDN or IP address field.
  4. Check the Reset Host Fingerprint checkbox.
  5. Click Save.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\