PowerProtect Data Manager 19.10 Administration and User Guide

PDF

Enable a disabled protection policy

To reenable a disabled policy, perform the following steps:

Steps

  1. From the PowerProtect Data Manager UI, select Protection > Protection Policies.
  2. Select one or more policies in Disabled state. You can also select the checkbox at the top of the table to select all policies on the current page.
  3. Click Enable.

Results

The status changes to Enabled. Primary backups for the reenabled policies resume according to the protection policy schedule.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\